Carbide-Drill 10,0 x 120 mm

Hard Metal Drills with Carbide - Cone PointApplicable for all standard-uses in the locksmith field. The prizes refer respectively to a piece.Shank Diameter: 6,0 x 100 mm  

Hard Metal Drills with Carbide - Cone PointApplicable for all standard-uses in the locksmith field. The prizes refer respectively to a piece.Shank Diameter: 5,5 x 85 mm  

The door can be unlocked with the universal key after removing the cylinder. The calibration to determine the length of the cylinder is very practical. Version: metal.Art-No. 2030 Universal Key “long”Art-No. 2031 Universal Key “short”  

For safe and fast Emergency Door Openings Compared with our module 1 „Pulling“, we have assembled our module 2 „Breaking“ with our approved Power Pull Cracker for profile cylinder breaking and the necessary accessories. Cylinder breaking /cracking may be easier by using a special pull screw which avoid slipping off the cylinder lock. Notice: The colored borders of the transparent module bags lid may vary. 

For safe and fast Emergency Door Openings. This emergency opening module kit provides tools for safe and quick opening of locked doors.This emergency opening kit provides tools for safe and quick opening of locked doors. In addition to the "Bell" (Glocke), which is an essential and important tool for emergency opening service providers, we have also incorporated a wide range of other accessories ranging from a ratchet wrench to pull screws into this module bag.Note: The colour of the transparent flap of the module bag may vary. 

Opening-Set for single- and double-offset doorsEvery locksmith knows the problem of closed double-offset doors. The new ACE spiral needles, made of high quality spring steel, allow the non-destructive opening of double-offset doors in most cases. The use is very simple: The tool is inserted in the narrow gap between door and frame by turning until it makes contact with the latch. Continued turning pushes back the latch. Usually this process does not cause any damages except a pierced sealing strip. The set consists of four (4) different tools for doors with the lock mounted either on the right or on the left and 2 different material strengths (1.5 and 1.7 mm) for the different types of offset door designs. Of course, the ACE-tools are very well suited for opening simple offset doors as well!For very tightly engaging (closing) double and simple offset doors the ACE-Mini-Set (2 pieces) of only 1.25 mm needle-strength is especially suited.