Accessories ARES

Basically, this handle can be used in the same way as the V2 turning aid handle. The difference is the length of the handle. This is approximately 78 mm for handle V1. 

This handle is intended as an optional aid. In each of the cases 2, 3 and 4 there are 2 of these handles. The handle is used to apply more pressure during pre-tensioning (Dimple locks) and, depending on the application, it gives a better hold of the tool as well as a better feel during tensioning. A maximum of 3 handles can be attached to the tool. These are screwed into the corresponding threaded bores on the lateral surface. It is entirely up to the user to choose whether to use 1, 2 or 3 handles. Based on our experience, one handle is sufficient. Handle length V2: approx. 53mm 

The disc turner-D03 is a tool intended for pre-positioning the discs in the cylinder. Before you commence setting the individual discs, the disc turner is inserted into the keyway and turned in a clockwise direction until it comes to a stop. This sets all the discs in an initial position. Then you can start setting the discs.