Handle incl. Opening-Card 0.25 mm

Door Latch Opening Cards with Handle At last, we can offer you a practical handle for our latch opening cards. The handle makes working much more comfortable. The special feature is that latch opening cards can be punched with a simple paper punch and then be fit into the handle. This very helpful tool is made of highly durable plastic.  

Door Latch Opening Cards with Handle At last, we can offer you a practical handle for our latch opening cards. The handle makes working much more comfortable. The special feature is that latch opening cards can be punched with a simple paper punch and then be fit into the handle. This very helpful tool is made of highly durable plastic.  

This lock cracker breaks even cylinders only slightly projecting thanks to a powerful clamp which is acting from underneath. With this tool you may facilitate the cylinder cracking by inserting a special pulling screw into the cylinder which prevents the lock cracker from slipping off. You remove the tool head from the shaft, place and fix it on the cylinder. Then you screw a suitable special pulling screw into the cylinder, using a Torx 20 bit, 50 or 70 mm long (Article: 2128 + 2129). 

This simple and very useful tool allows the user to pull down the door handle on the other side of the door. The Door Handle-Catch is simply inserted in the gap between door and floor, then lifted up and adjusted above (around) the door handle. Using the pulling-rope on the outside, the handle is then pushed down.  In many cases this is the easiest and fastest method of opening closed but unlocked doors. A necessary precondition for the successful use of the handle-catch is a sufficiently wide gap (at least 4.0 mm) between door and floor or a door-strip that can be removed to create a sufficiently wide gap. The door handle catch can also be used with double rebate doors.In combination with the Door Handle Catch, the Air-Wedge can be very efficient. Length of pulling rope: approx. 110 cm.The door handle catch can also be used with double rebate doors. 

The new Latch Opener Set (2 pieces: 1x 1.5mm and 1x 1.75 mm, made of spring steel wire, with handle) is especially designed for the opening of double-offset doors. After pulling the door out of its frame for a little distance, using the Multi-Opener, Door Lever or Suction Cup etc., the appropriate latch opener is inserted into the gap and pulled up into the direction of the latch. Be careful not to rip out the sealing while doing so. When touching the latch with the tool’s tip, twist the tip of the tool against the latch and the door will open.