Magnetic Lifter

This simple and very useful tool allows the user to pull down the door handle on the other side of the door. The Door Handle-Catch is simply inserted in the gap between door and floor, then lifted up and adjusted above (around) the door handle. Using the pulling-rope on the outside, the handle is then pushed down.  In many cases this is the easiest and fastest method of opening closed but unlocked doors. A necessary precondition for the successful use of the handle-catch is a sufficiently wide gap (at least 4.0 mm) between door and floor or a door-strip that can be removed to create a sufficiently wide gap. The door handle catch can also be used with double rebate doors.In combination with the Door Handle Catch, the Air-Wedge can be very efficient. Length of pulling rope: approx. 110 cm.The door handle catch can also be used with double rebate doors. 

The latch opening cards are made from a type of plastic specifically created for their use. They allow a fast and easy opening of doors that are “only” closed, but not locked. Especially in cases where the gap between door and frame is too narrow for the use of latch pick needles these cards can prove their usefulness. 

The Multipick ELITE Ultradecoder is designed to decipher the combination of multi wheeled locks. By placing the Ultradecoder on the axle that runs through the wheels inside the lock the operator can feel for changes in the features of the axle. Flat spots or grooves on the axle can be felt by the Ultradecoder as the operator spins the wheels. These flat spots or grooves will reveal the locks combination. By using the decoder on the axle beside each wheel the operator can line up all the flat spots or grooves to the same position. When this is done the combination will be set. The final step is to move combination into the correct position. Simply roll each wheel down one position and test the lock to open. Repeat this process until it does open.The Ultradecoder is made from thin high test steel with a solid steel handle.This decoder can also be used to depress the locking bar inside the Master 175 and other similar models quickly opening the lock. 

The Multipick ELITE SHANK quickly opens a large variety of everyday locks including most Filing Cabinets and Tool Chests! When used properly the SHANK will open the lock within seconds without any damage. Simply insert the SHANK through the key way and wiggle while turning the knife releasing the locking pawl and opening the lock.The Multipick ELITE Shank works on the following models and many more:File Cabinets & Tool ChestsHonWaterlooHudsonStanleyS&GYaleChicago6842CraftsmanEagleHuskyFraim PadlocksSlaymakerHerculesLudell,Master 77Sargent 752HS & 753HSTaylor 781 padlocks 

Opening-Set for single- and double-offset doorsEvery locksmith knows the problem of closed double-offset doors. The new ACE spiral needles, made of high quality spring steel, allow the non-destructive opening of double-offset doors in most cases. The use is very simple: The tool is inserted in the narrow gap between door and frame by turning until it makes contact with the latch. Continued turning pushes back the latch. Usually this process does not cause any damages except a pierced sealing strip. The set consists of four (4) different tools for doors with the lock mounted either on the right or on the left and 2 different material strengths (1.5 and 1.7 mm) for the different types of offset door designs. Of course, the ACE-tools are very well suited for opening simple offset doors as well!For very tightly engaging (closing) double and simple offset doors the ACE-Mini-Set (2 pieces) of only 1.25 mm needle-strength is especially suited.