Latch opener set 1.5+1.7 mm double offset w/o handle

The auxiliary milling key is designed to address malfunctions that occur after the milling process.For cylinders with emergency and danger functions, the cam coupling is held in place by pressing the auxiliary milling key into the center of the cylinder while turning it. If the coupling becomes stuck, a light tap with a hammer can help release it.For standard cylinders, vibrations during the milling process may cause the coupling to shift forward. To resolve this, hold the keyway in a vertical position and use the auxiliary milling key to push the coupling inward, allowing the cam to rotate freely.If a key is lodged inside the cylinder, use a 1 mm pointed spring steel wire, such as our Coupling Actuator (SKU: 3138), which can be purchased separately. Press the wire against the edge of the core while simultaneously turning the auxiliary milling key to move the cam. 

The 4 extractors are stored in the hollow handle and can be place in the tension holder when needed. This saves place while at the same time allowing an optimal handling. These extractors vary greatly from the Extractor Set 2000. The spiral-shaped are turned into the keyway below the broken-off key and in most cases allow an easy extraction of key-parts. 

This simple and very useful tool allows the user to pull down the door handle on the other side of the door. The Door Handle-Catch is simply inserted in the gap between door and floor, then lifted up and adjusted above (around) the door handle. Using the pulling-rope on the outside, the handle is then pushed down.  In many cases this is the easiest and fastest method of opening closed but unlocked doors. A necessary precondition for the successful use of the handle-catch is a sufficiently wide gap (at least 4.0 mm) between door and floor or a door-strip that can be removed to create a sufficiently wide gap. The door handle catch can also be used with double rebate doors.In combination with the Door Handle Catch, the Air-Wedge can be very efficient. Length of pulling rope: approx. 110 cm.The door handle catch can also be used with double rebate doors. 

For the easy opening of “only” closed but unlocked doors. Small, very efficient and almost indestructible set of needles. The best we know! 

A single set for many door-opening possibilities. This 9-piece set offers you the answer to the most common door-opening issues. Due to the varied bendings of the 1.7 mm wires, there will certainly be a suitable wire for your task. A set that should be part of every locksmith's tool kit.Scope of Delivery:• 1x Standard double rebate wire needle• 1x Double rebate wire needle for rebate windows• 1x Standard single rebate wire needle• 1x Single rebate wire needle for fire resistant doors• 1x Single rebate wire needle for aluminium doors• 1x Single rebate wire needle for uPVC doors• 1x Single rebate wire needle for uPVC/metal doors• 1x Single rebate wire needle for panic doors (outward opening)• 1x Spring wire for cylinder clutch and for dismantling BKS round cylinders