Handle Lever for profile cylinders

This door latch pick needle set consists of 4 pre-shaped needles (Ø 1.5 mm). 

The popular panic door opener is now available as a set for door opening right and left. No difficult operation anymore thanks to the coverage of all opening directions. Practical and effective! For the opening of closed doors that open to the outside, single-offset doors, i.e. those that can be found in public buildings and emergency exits. In order to insert the tool into the gap between frame and door it is often necessary to broaden this gap using a suction cup or our Multi-Opener. Depending on the door, this application can require different techniques therefore it’s advisable to be prepared for all possibilities! Extending the door gap can accomplished e.g. with a strong siphon, door wedges or a door lever.Special:Spring steel blade, only 1mm thick. Also available individually33800 = Door use from the top right33805 = Door use from the top left  

The new Latch Opener Set (2 pieces: 1x 1.5mm and 1x 1.75 mm, made of spring steel wire, with handle) is especially designed for the opening of double-offset doors. After pulling the door out of its frame for a little distance, using the Multi-Opener, Door Lever or Suction Cup etc., the appropriate latch opener is inserted into the gap and pulled up into the direction of the latch. Be careful not to rip out the sealing while doing so. When touching the latch with the tool’s tip, twist the tip of the tool against the latch and the door will open. 

Important: This tool does not open locks with anti-pick system! Since this decoder is designed for double-bit lever lock Arfe safe 3x3 pins, its construction is accordingly. The pick consists of a rod with 3x3 pins. These pins are arranged in a specific order to match the intended lock. The pins are tightened in the back part of the handle by a pin manipulator. When this is tight, the pins will be difficult to move. If it is loose, the pins can be moved more easily. Preparation You take one of the two springs and put it into the slot in the front of the handle. Afterwards remove the cover of the housing (which is on the back). Then insert the rod into the handle as demonstrated in the video, and securely tighten it to the handle with the Allen key and insert the pin manipulator by screwing it into the back of the handle. The ease of movement of the pins is the most important thing. If they are tight, the opening process will not be successful! Lastly, mount the small tensioning handles. Now the decoder is ready for use. Opening and repairing procedure with the double-bit lock decoder Make sure that the decoder is used for the appropriate lock. Insert the tool with the pins that correspond to the position of the levers inside the lock. Now start the opening procedure. By tensioning it over the tensioning handles several times, the decoder raises each tumbler to a certain height so that the bolt can move. Finally, the pins "adopt" the position corresponding to the position of the "ridges" of the original key. Moreover, the double-bit lock decoder is easy to assemble and disassemble. Another important aspect is the ease of repairing a broken or twisted pin - simply unscrew the pin manipulator and replace the damaged pin. This lockpick tool works in a non-destructive way. Each tool can be used for a specific lock - in this case Arfe safe 3x3 or for locks with similar dimensions. The internal dimensions of the locks (the size of the original key) are crucial. This means that you have to know the number of levers and the distance between the levers before using a lockpick tool. 

The 2 piece key turner set gives you the opportunity of opening warded locks (e.g. room doors) where the key is still inserted on the other side. Depending on the directions in which the lock has to be opened, one of the appropriate key turners must be selected. It's a very helpful tool, especially in combination with our lever picks.