Carbide-Drill 5,0 x 85 mm

Hard Metal Drills with Carbide - Cone PointApplicable for all standard-uses in the locksmith field. The prizes refer respectively to a piece.Shank Diameter: 4,0 x 75 mm 

Hard Metal Drills with Carbide - Cone PointApplicable for all standard-uses in the locksmith field. The prizes refer respectively to a piece.Shank Diameter: 6,0 x 100 mm  

Special Drill Bits for Vaults (Hard Plate V Tip®) 6.8 x 150 mmThese special drill bits are very well suited for the drilling of very hard materials. With their special notched carbide tip they drill up to 50% faster through these types of materials compared to traditional drill bits.Shank Diameter: 6.05 mm 

The latch opening cards are made from a type of plastic specifically created for their use. They allow a fast and easy opening of doors that are “only” closed, but not locked. Especially in cases where the gap between door and frame is too narrow for the use of latch pick needles these cards can prove their usefulness. 

This simple and very useful tool allows the user to pull down the door handle on the other side of the door. The Door Handle-Catch is simply inserted in the gap between door and floor, then lifted up and adjusted above (around) the door handle. Using the pulling-rope on the outside, the handle is then pushed down.  In many cases this is the easiest and fastest method of opening closed but unlocked doors. A necessary precondition for the successful use of the handle-catch is a sufficiently wide gap (at least 4.0 mm) between door and floor or a door-strip that can be removed to create a sufficiently wide gap. The door handle catch can also be used with double rebate doors.In combination with the Door Handle Catch, the Air-Wedge can be very efficient. Length of pulling rope: approx. 110 cm.The door handle catch can also be used with double rebate doors.