Milling Burr "Vampire" 4 x 6 x 60 mm

This solid carbide milling burr 4 x 6 x 60 mm is cut off one piece. It distinguishes itself through rough drilling features, due to its deep cuts, which also leads to a good chipping removal.

Special features:

Due to the reduction of a 6 mm drill burr to 4 mm at the tip, working time is reduced by more than half, for less material has to be cut. A pleasant side effect: the core drawing protection doesn’t have to be destroyed thanks to the small milling burr head diameter.

Technical features:

Material: Solid carbide
Form: cylindrical
d1: 4.0 mm
I1: 14.0 mm
d2: 6.0 mm
I2: 60 mm
Toothing: crossed toothing for unsiversal use
Coating: none

Application possibilities:     

• tough and high-strength material
• alloyed steel casting
• synthetic material    
• universal usage
• highest chip removal

Strongly recommended for the following materials:

• Brass
• Copper
• Cast iron
• Bronze
• Pure steel
• Hardened steel
• Stainless steel
• High-Grade steel
• Titan