Schlagschlüssel-Satz, Bohrmulden, 6-tlg.

Flex-Hammer IThe extreme flexibility and elasticity of the hammer handle allows the bump key to “jump” back out of the keyway immediately after being hit. This effect is very positive in the technique of bumping and we therefore recommend this hammer for beginners and people using common bumping technique. Weight : 74 g Length: 210 mm Flex-Hammer IIThe handle of this bump hammer is less flexible. The hammer is for all those users who already master or want to master the advanced bumping technique of “cushioned bumps”. Here the bump key is held between thumb and index finger. When hitting the bump key the fingers act as a cushion against the cylinder, again allowing the key to “jump” back out. Weight : 74 g Length: 210 mm During our tests these complementary characteristics of both hammers meant that we effectively needed significantly less tries to open a wide range of different cylinders. Special characteristics:comfortable, non-slip handleheavy, round plastic head allows exact and well aimed hits from different angleswell balanced weight repartition  

 

Contains:  2 Springs - 15 mm1 Buffer Protector - 2.0 mm1 Trick Buffer - 6.0 mm2 Buffer Discs - 1.0 mm2 Buffer Discs - 1.5 mm2 Buffer Discs - 3.0 mm1 Buffer Disc - 5.0 mm  

The popular panic door opener is now available as a set for door opening right and left. No difficult operation anymore thanks to the coverage of all opening directions. Practical and effective! For the opening of closed doors that open to the outside, single-offset doors, i.e. those that can be found in public buildings and emergency exits. In order to insert the tool into the gap between frame and door it is often necessary to broaden this gap using a suction cup or our Multi-Opener. Depending on the door, this application can require different techniques therefore it’s advisable to be prepared for all possibilities! Extending the door gap can accomplished e.g. with a strong siphon, door wedges or a door lever.Special:Spring steel blade, only 1mm thick. Also available individually33800 = Door use from the top right33805 = Door use from the top left  

Lifter for security-fittings usually allow lifting of the security fitting in order to insert a square bolt knife into the gap and turn the handle mechanism.Normally this opening technique is only possible with simple fittings which are not screwed together. The device of the “Bridge” lifter for fittings is fixed to the exterior door handle. On regular pulling by use of the screws the fitting comes off the door leaf by a few millimeters. The adapted square bolt knife will be inserted to the gap and the lock will be opened by turning the square bolt. NEW! Highly durable and long lasting construction. Big advantage due to new special trapezoidal thread which makes it easy to tighten - this prevents the thread from "seizing". The regular and smooth pulling of the fitting by the 2 screws of the Bridge should be careful since pressure marks of the tools’ feet may occur in case of inattention! The respective square bolt knives (8 mm and 10 mm) are included. Also this tool is very well adapted together with our emergency set for broken latch. A 17 mm driver is needed in order to turn the screws lifting the fitting! The “Bridge” differs essentially from the other lifters on the market in the following ways:Assembly of high-value aluminiumDespite new light weight construction extremely loadableVery solid finishingExtremely high durabilityOptimal exertion and distribution of pulling forceBig advantage due to new special trapezoidal threadQuick identification of bolt diameter through millimeter markings