Cobalt-Drill Set 19 pcs. 1-10 mm

The latch opening cards are made from a type of plastic specifically created for their use. They allow a fast and easy opening of doors that are “only” closed, but not locked. Especially in cases where the gap between door and frame is too narrow for the use of latch pick needles these cards can prove their usefulness. 

The (in our opinion) perfect Door Latch Slider The latch opening slider “TFG” completes our selection of tools for the opening of closed but unlocked doors . We are absolutely enthusiastic about the tool’s effectiveness and quality and use the "TFG" on an almost daily basis ourselves. The "TFG" comes in 5 different sizes: 15, 20, 25, 30 & 35 mm, each size optimized for the different types of offset door designs. Experience tells us that there is no better tool for the simple opening of closed but unlocked doors. Put this to the test yourself! The use is incredibly easy! Insert the "TFG" in the gap between door and frame, slide it down to the latch and the door opens.It is made out of highly flexible spring steel and is only as thick as 0.8 mm. The "TFG" can be used effectively almost everywhere. The "TFG" has no sharp edges, and does not cause scratches or other damages on the door or the frame. If the sliding of the "TFG" is made difficult by the sealing strip, lubrication of the "TFG" is very effective. 

A Wiha Torx T-20 T-Key or Bit is required for the screw-driving the pull screws.  

This special tool developed for locksmiths and government agencies allows the easy and hassle-free removal of all types of cylinder locks (profile, round and oval cylinders). The ‘’Bell‘’ enables the door to be opened quickly without damaging the door or the fitting.In combination with the included core pulling plates, the cylinder core alone can be easily extracted from the housing so that the locking mechanism can be actuated without any difficulty. Especially with half cylinders, such as those found on glass doors, garage doors, alarm systems, shutters etc., to save time, deploying the "Bell" is often the only option when it comes to opening the door in an emergency. As the device works with a single and centrally oriented pulling-mechanism, there are no lateral forces during the actual pulling. This prevents the special extraction screws from jamming or snapping.For its compact and robust design and the effective mode of operation, the "Bell" is considered one of the best plug-pulling devices among professionals around the world. The "Bell" is made of hardened steel to ensure years of use.The tension rod is equipped with a hardened trapezoidal thread that enables precise operation and improved load bearing. Compared to the conventional fine thread, this new thread is more durable and allows faster and more precise operation without losing any torque due to the greater thread pitch. Furthermore, the rougher trapezoidal thread is less susceptible to brass shavings.If you should ever need spare parts, just give us a call! We constantly have all spare parts in stock.Care instructions for Multipick Bell (Please pay attention to these instructions!) Just like any other tool, our lock puller "Multipick Bell" also requires care. This means that the ball bearing and the tension rod as well as all moving parts should be kept free of metal shavings after each use and regularly treated with lubricating grease. You can either apply it by means of a brush or, alternatively, using a similar spray grease. 

This lock cracker breaks even cylinders only slightly projecting thanks to a powerful clamp which is acting from underneath. With this tool you may facilitate the cylinder cracking by inserting a special pulling screw into the cylinder which prevents the lock cracker from slipping off. You remove the tool head from the shaft, place and fix it on the cylinder. Then you screw a suitable special pulling screw into the cylinder, using a Torx 20 bit, 50 or 70 mm long (Article: 2128 + 2129).