Square Bolt Knife 10 mm

Lifter for security-fittings usually allow lifting of the security fitting in order to insert a square bolt knife into the gap and turn the handle mechanism. Normally this opening technique is only possible with simple fittings which are not screwed together. 

Lifter for security-fittings usually allow lifting of the security fitting in order to insert a square bolt knife into the gap and turn the handle mechanism. Normally this opening technique is only possible with simple fittings which are not screwed together. 

Opening-Set for single- and double-offset doorsEvery locksmith knows the problem of closed double-offset doors. The new ACE spiral needles, made of high quality spring steel, allow the non-destructive opening of double-offset doors in most cases. The use is very simple: The tool is inserted in the narrow gap between door and frame by turning until it makes contact with the latch. Continued turning pushes back the latch. Usually this process does not cause any damages except a pierced sealing strip. The set consists of four (4) different tools for doors with the lock mounted either on the right or on the left and 2 different material strengths (1.5 and 1.7 mm) for the different types of offset door designs. Of course, the ACE-tools are very well suited for opening simple offset doors as well!For very tightly engaging (closing) double and simple offset doors the ACE-Mini-Set (2 pieces) of only 1.25 mm needle-strength is especially suited. 

The popular panic door opener is now available as a set for door opening right and left. No difficult operation anymore thanks to the coverage of all opening directions. Practical and effective! For the opening of closed doors that open to the outside, single-offset doors, i.e. those that can be found in public buildings and emergency exits. In order to insert the tool into the gap between frame and door it is often necessary to broaden this gap using a suction cup or our Multi-Opener. Depending on the door, this application can require different techniques therefore it’s advisable to be prepared for all possibilities! Extending the door gap can accomplished e.g. with a strong siphon, door wedges or a door lever.Special:Spring steel blade, only 1mm thick. Also available individually33800 = Door use from the top right33805 = Door use from the top left  

This simple and very useful tool allows the user to pull down the door handle on the other side of the door. The Door Handle-Catch is simply inserted in the gap between door and floor, then lifted up and adjusted above (around) the door handle. Using the pulling-rope on the outside, the handle is then pushed down.  In many cases this is the easiest and fastest method of opening closed but unlocked doors. A necessary precondition for the successful use of the handle-catch is a sufficiently wide gap (at least 4.0 mm) between door and floor or a door-strip that can be removed to create a sufficiently wide gap. The door handle catch can also be used with double rebate doors.In combination with the Door Handle Catch, the Air-Wedge can be very efficient. Length of pulling rope: approx. 110 cm.The door handle catch can also be used with double rebate doors.